little, and start again. As soon as they go well, drive them over a small
hill a few times, and then over a large one, occasionally adding a little
load. This process will make any horse true to pull.


TO BREAK A HORSE TO HARNESS.

Take him in a tight stable, as you did to ride him; take the harness and
go through the same process that you did with the saddle, until you get
him familiar with them, so that you can put them on him and rattle them
about without his caring for them. As soon as he will bear this, put on
the lines, caress him as you draw them over him, and drive him about in
the stable till he will bear them over his hips. The _lines_ are a great
aggravation to some colts, and often frighten them as much as if you were
to raise a whip over them. As soon as he is familiar with the harness and
line, take him out and put him by the side of a gentle horse, and go
through the same process that you did with the balking horse. Always use a
bridle without blinds when you are breaking a horse to harness.


HOW TO HITCH A HORSE IN A SULKY.

Lead him to and around it; let him look at it, touch it with his nose, and
stand by it till he does not care for it; then pull the shafts a little to
the left, and stand by your horse in front of the off wheel. Let some one
stand on the right side of the horse, and hold him by the bit, while you
stand on the left side, facing the sulky. This will keep him straight. Run
your left hand back and let it rest on his hip, and lay hold of the shafts
with your right, bringing them up very gently to the left hand, which
still remains stationary. Do not let anything but your arm touch his back,