concrete. The concrete floor was the first part of the lining to be
put in place. Rails were laid on it for a traveler having moulds
attached to its sides, against which the walls were built. A similar
traveler followed with the centering for the arch roof, a length of
about 50 feet being completed at one operation.

[Illustration: FOUR COLUMN (TOWER) VIADUCT CONSTRUCTION]

[Illustration: MANHATTAN VALLEY VIADUCT, LOOKING NORTH]

[Illustration: ERECTION OF ARCH, MANHATTAN VALLEY VIADUCT]

On the Park Avenue section from 34th Street to 41st Street two
separate double-track tunnels were driven below a double-track
electric railway tunnel, one on each side. The work was done from four
shafts, one at each end of each tunnel. At first, top headings were
employed at the north ends of both tunnels and at the south end of the
west tunnel; at the south end of the east tunnel a bottom heading was
used. Later, a bottom heading was also used at the south end of the
west tunnel. The rock was very irregular and treacherous in character,
and the strata inclined so as to make the danger of slips a serious
one. The two headings of the west tunnel met in February and those of
the east tunnel in March, 1902, and the widening of the tunnels to the
full section was immediately begun. Despite the adoption of every
precaution suggested by experience in such work, some disturbance of
the surface above the east tunnel resulted, and several house fronts
were damaged. The portion of the tunnel affected was bulkheaded at
each end, packed with rubble and grouted with Portland cement mortar
injected under pressure through pipes sunk from the street surface
above. When the interior was firm, the tunnel was redriven, using much