pressure needed.

The source of current for the resistance welder must be alternating, that
is, the current must first be negative in value and then positive, passing
from one extreme to the other at rates varying from 25 to 133 times a
second. This form is known as alternating current, as opposed to direct
current, in which there is no changing of positive and negative.

The current must also be what is known as single phase, that is, a current
which rises from zero in value to the highest point as a positive current
and then recedes to zero before rising to the highest point of negative
value. Two-phase of three-phase currents would give two or three positive
impulses during this time.

As long as the current is single phase alternating, the voltage and cycles
(number of alternations per second) may be anything convenient. Various
voltages and cycles are taken care of by specifying all these points when
designing the transformer which is to handle the current.

Direct current is not used because there is no way of reducing the voltage
conveniently without placing resistance wires in the circuit and this uses
power without producing useful work. Direct current may be changed to
alternating by having a direct current motor running an alternating current
dynamo, or the change may be made by a rotary converter, although this last
method is not so satisfactory as the first.

The voltage used in welding being so low to start with, it is absolutely
necessary that it be maintained at the correct point. If the source of
current supply is not of ample capacity for the welder being used, it will
be very hard to avoid a fall of voltage when the current is forced to pass