in long strips, 1 inch wide, is used for nitration by the Xylonite
Manufacturing Company, of North Adams, Mass. (U.S.A.).

The Celluloid Company introduce the cut paper into the mixed acids by
means of a hollow, rapidly revolving tube, flared at the lower end, and
immersed in the mixed acids. The centrifugal force of the revolving tube
throws the paper towards the sides of the vessel, leaving the centre of
the vessel ready for fresh paper.

The Xylonite Company simply cut the paper into long strips, and introduce
it into the mixed acids by means of forks. The arrangement used by this
Company for holding the mixed acids is a cylindrical vessel divided into a
number of sections, the whole revolving like a turntable, thus allowing
the workman to nitrate successively each lot of paper at a given point.
This Company did not remove the acid from the paper after its immersion,
but plunged it immediately into the water, thus losing a large proportion
of the waste acid. The Celluloid Company, by using the paper in smaller
pieces, and more paper to a pound of acid, and wringing the mixed acid
from the paper before immersion in water, had a better process of
nitration.

Other manufacturers use earthenware vessels, and glass or steel rods,
hooked at one end, having small pieces of rubber hose pulled over the
other end to prevent the hand from slipping. The form of vessel in general
use is that given in Fig. 23. It is large enough to nitrate 1 lb. of
cotton at a time. The hook at one end of the rod enables the workman to
pull the pyroxyline apart, and thus ensures saturation of the fibre. In
the winter the room in which the nitrating is done must be kept at a
temperature of about 70° F. in order to secure equality in the batches.